Change The Traffic Statistics Polling Frequency - NETGEAR WAC104 User Manual

4. Select Administration > Status.
The following table describes the fields and columns of the table on the page.
Field or Column Description
System Up Time The time elapsed since the AP was last restarted.
Port The statistics for the LAN (Ethernet) ports, WLAN b/g/n, and WLAN a/n/ac ports. For
each port, the page displays the information that is described in this table.
Status The link status of the port.
TxPkts The number of packets transmitted on this port since reset or manual clear.
RxPkts The number of packets received on this port since reset or manual clear.
Collisions The number of packets that collided on this port since reset or manual clear.
Tx B/s The detected rate of packet transmission in bytes per second on this port.
Rx B/s The detected rate of packet reception in bytes per second on this port.
Up Time The time elapsed since this port acquired the link.
Poll Interval The interval at which the statistics are updated on this page. For more information,
see Change the traffic statistics polling frequency on page 65.

Change the traffic statistics polling frequency

You can change the polling frequency or stop traffic polling. For information about the
traffic statistics, see View the traffic statistics on page 64.
Manage the AP and Monitor the
Traffic
802.11ac Wireless Access Point Model WAC104
65 User Manual