Manage The Wps Settings - NETGEAR WAC104 User Manual

Note: If you are connected to the AP over a WiFi connection, make sure that you
add your own WiFi device to the access control list before you enable access control.
10. Select the Turn Access Control On button.
11. Click the Apply button.
The access control list is saved and the Advanced Wireless Settings page displays
again.
12. Click the Apply button.
Your settings are saved and the access control list becomes active. Only WiFi devices
that are on the access control list are now allowed to connect to the WiFi network
of the AP.

Manage the WPS settings

Wi-Fi Protected Setup (WPS) lets you join the WiFi network without typing the WiFi
password. You can change the WPS default settings.
To manage the WPS settings:
1. Connect your computer or mobile device to the AP in one of the following ways:
• Connect directly to the AP's WiFi network or LAN.
• Connect to the same network that the AP is connected to.
2. Launch a web browser and enter http://www.aplogin.net (or aplogin.net) in the
address field.
Instead, if you are connected to same network as the AP, enter the LAN IP address
that is assigned to the AP. For information about finding the IP address, see Find the
IP address of the AP when you cannot use aplogin.net on page 24.
A login window displays.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The Home page displays.
4. Select Advanced Setup > Advanced Wireless Settings.
The Advanced Wireless Settings page displays.
Manage the Advanced WiFi
Features
802.11ac Wireless Access Point Model WAC104
73 User Manual