Use The Reset Button; Erase The Settings - NETGEAR WAC104 User Manual

Use the Reset Button

CAUTION:
This process erases all settings that you configured in the access point.
To reset the access point to factory default settings:
1. On the back of the access point, locate the recessed Reset button to the left of the Power On/Off button.
2. Using a straightened paper clip, press and hold the Reset button for at least five seconds.
3. Release the Reset button.
The configuration is reset to factory default settings. When the reset is complete, the access point
reboots. This process takes about two minutes.
WARNING:
To avoid the risk of corrupting the firmware, do not interrupt the reset. For
example, if you are connected to the access point web management interface,
do not close the browser, click a link, or load a new page. Do not turn off the
access point. Wait until the access point finishes restarting and the Power
LED remains solid green.

Erase the Settings

CAUTION:
This process erases all settings that you configured in the access point.
To erase the settings:
1. Open a web browser from a computer that is connected to the same network as the access point or to
the access point directly through an Ethernet cable or WiFi connection.
2. Enter the IP address that is assigned to the access point.
If you did not enable the DHCP client on the access point or did not assign a static IP address, enter
the default access point IP address 192.168.0.100.
A login window opens.
802.11ac Wireless Access
Manage the Access Point and Monitor the Traffic
45