Use The Wifi On/Off Button; Enable Or Disable The Wifi Radios - NETGEAR WAC104 User Manual

Use the WiFi On/Off button

To turn the WiFi radios off and on with the WiFi On/Off button:
Press the WiFi On/Off button on the rear panel of the AP for two seconds.
If you turned off the WiFi radios, the WiFi LED turns off. If you turned on the WiFi
radios, the WiFi LED lights solid green.
Tip: If you want to disable the WiFi radio or radios of the AP, use a wired connection
to avoid being disconnected when WiFi radio or radios turn off.

Enable or disable the WiFi radios

If you used the WiFi On/Off button to turn off the WiFi radios, you cannot log in to the
AP over a WiFi connection to turn them back on. You must press the WiFi On/Off button
again for two seconds to turn the WiFi radios back on.
To enable or disable the WiFi radios:
1. Connect your computer or mobile device to the AP in one of the following ways:
• Connect directly to the AP's WiFi network or LAN.
• Connect to the same network that the AP is connected to.
2. Launch a web browser and enter http://www.aplogin.net (or aplogin.net) in the
address field.
Instead, if you are connected to same network as the AP, enter the LAN IP address
that is assigned to the AP. For information about finding the IP address, see Find the
IP address of the AP when you cannot use aplogin.net on page 24.
A login window displays.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The Home page displays.
Manage the Basic WiFi Network
Settings
802.11ac Wireless Access Point Model WAC104
44 User Manual