Table of Contents
Advertisement
Instructions:
-
Remove keypad panel from the TR200
-
Remove the frame located beneath and discard
-
Push the option into place. Two positions are possible, with cable terminal facing either up or down
-
Push the serial communication bus option adaptor frame for the TR200 into place
-
Replace the keypad and attach cable
-
On A1 and A2 enclosures with cable terminal facing up: Fasten the cable onto the de-coupling plate (the
TR200 top surface has pre-drilled threaded holes for attaching the de-coupling plate to the unit).
TR200 LonWorks
How to install
4-7
Advertisement
Table of Contents
