Table of Contents
Advertisement
Page 18
KEY FOB ZONE ASSIGNMENT: Key fobs can also be assigned to zones to allow multiple wireless panic buttons on
one alarm system, each reporting to a central station, a pager or having a description on the keypad that describes the
person holding the key fob, the location where the person holding the key fob is stationed, or the special purpose of the
key fob button being depressed. See the next page on key fob Zone Assignment.
29
INTERIOR BYPASS FIRE/TBL SYS TBL CHIME
INTERIOR BYPASS FIRE/TBL SYS TBL CHIME
leading "0"s, if any).
1-digit checksum number printed on the transmitter (enter all numbers and/or letters, including leading "0"s, if any).
Aux-1 Option (see key fob aux 1 & aux 2 options).
Aux-2 Option (see key fob aux 1 & aux 2 options).
U
Press
to save. Press the NEXT/YES button to proceed.
DATA
AUX 1/AUX 2
ENTRY
OPTIONS
0
None
1
Relay Group 1 Toggle
2
Relay Group 2 Toggle
9
Panic
A
Auxiliary
B
Instant
C
PGM2 Output Toggle
D
Access on PGM2
Output
E
Arm Stay
F
Interior Button
controlled zones can be assigned, providing multiple wireless panic buttons on a system, each reporting to the Central Station or a
pager and/or annunciating on a keypad the key fob zone number with description/location. To assign a key fob to a zone:
program the key fob as you would a transmitter, entering the key fob's ID code, check sum and point number at the appropriate
zone. The "Quick Method" is not allowed. The zone may be hardwired to a sensor as well as assigned to a key fob (either one will
activate the zone alarm output). NOTE: If assigning a key fob to a zone, the "ON/OFF" buttons on the key fob will no longer arm/
disarm the system. The key fob is converted to a "panic only" device.
X
GEM-P1664 Programming Instructions
Key Fob Transmitters (Press
Keyfobs can be programmed as "Arm/Disarm" devices (refer to WI752).
For each Key Fob Transmitter, enter:
The Key Fob Transmitter number (01–08).
Area number to which transmitter is assigned (1 - 4); enter 0 to disable keyfob.
The 6-digit RF ID # printed on the transmitter (enter all numbers and/or letters, including
NOTE: Key fobs 1-8 report
openings
and
Users 57-64.
Note: If the Key Fob is converted for Two Button "Emergency Use" (by cutting an internal
jumper), both top or bottom buttons must be depressed to activate an alarm. In this case, the
Aux-1 and Aux-2 cannot be programmed.
Key Fob Transmitters as Zone Input Devices (refer to display above: press the PRIOR/NO
button to go backwards).
Each of the 4 key fob buttons can be assigned to a zone. For example, On button = point 1; Off
button = point 2; A1 = point 3; A2 = point 4. Up to 64 key fobs (using 1 button) or 32 key fobs
(using 2 buttons) or 16 key fobs (using all 4 buttons) or any combination up to a maximum of 64
to set cursor).
R
closings
as
L
WI1423A 1/06
NAPCO Security Systems
Advertisement
Table of Contents
