Connecting The Seconfig Software To The Switcher - Datavideo HS-2850 Instruction Manual

Note: To reset the IP Address of the PC/laptop use the Network and Sharing Center option
in Windows 7 Control Panel. Click on Local Area Connection then Properties. Click to
highlight Internet Protocol Version 4 (TCP/IPv4) then click Properties again. Then click Use
the following IP address.

3.2 Connecting the SEConfig Software to the Switcher

1. Double click the SEConfig DV icon to launch the application.
2. If you immediately get an error
window, do not worry, this just means
the "PC Control" button in the MENU
area of the HS-2850 keyboard has not
been enabled.
3. Make sure the "PC Control" button is
enabled and then click OK.
4. Select Ethernet
Computer's IP Address. Click the Find
button to find and display the HS-2850
Switcher's IP Address in the drop down
list. The first three numbers in both IP
addresses should match. See the
example on the left.
36
to display the