Table of Contents
Advertisement
REC & PLAY Functions
Left mouse click the grey REC button and it will light up red. All of your actions when using
the Remote Console will now be recorded to file. The only action that will not be recorded is
the T-Bar, use the CUT or AUTO TAKE buttons instead. The function buttons just above the
T-Bar as listed on this page are also ignored.
Click the red REC button again and a save window will appear. You can now save the
recorded actions as a macro text file to a chosen location on the computer.
Click the grey PLAY button and a load file window will appear. You can now browse to and
load a macro text file. When you load a file the recorded actions will begin to play back until
the end of the file.
Software-based Macro Functions
It is possible to record a Macro type playlist to the computer when using the SE Remote
software. This Macro function allows these pre-recorded keyboard actions or selections to
be played back within a project where timing is important or where the same steps are
repeated throughout the production. The Macro function buttons are REC, and PLAY. These
buttons are located just above the T-Bar in the SE Remote display above.
TIME Function
This button is located just above the T-Bar in the SE Remote display above. Mouse clicking
on the TIME button will synchronize the time on the HS-2850 switcher to the current time
on the computer.
2.3 Intercom & Monitor Control Panel
Intercom Function
Monitor Function
27
Advertisement
Table of Contents
