Pc Control - Se Remote Control Software - Datavideo HS-2850 Instruction Manual

H-Timing
Factory Settings
Horizontal Position (Left to
Right)
Vertical Position (Lower to
Upper)
SET Hours
SET Minutes
Clear Seconds
A: M1=PVW+PGM+3 IN; M2=9 IN
B: M1=PVW+PGM+12 IN; M2=PGM
C: M1=PVW+PGM+8 IN; M2=PGM
D: M1=PVW+PGM+12 IN; M2=M1
E: M1=PVW+PGM+8 IN; M2=M1
Input Select
Time Delay
Mode
Input 1-12
Preview
Program
Ethernet
RS422
2.2.8 PC Control – SE Remote Control Software
It is possible to control the HS-2850 with a Windows 7 computer using an Ethernet
connection. The SE Remote software supplied with the switcher needs to be installed on the
computer first. The HS-2850 then needs to be placed into PC Control mode. To do this press
the PC Control button on the HS-2850 Control Panel. Once launched, the Remote software
displays an image of the HS-2850's keyboard as shown below. Any active functions or
selections will be shown with a red button or key. These buttons or keys can be clicked with
a mouse or alternatively you could use a touch screen monitor.
SD: Composite Signal
0-255
Factory Settings
Tick selection for ON or OFF
Clock Settings
000-110
000-124
0-23
0-59
Tick selection for clearing second
Multi Screen Mode
This option sets HDMI outputs 1 and 2.
GPI Settings
00-12
In frames between 1 to 75
Level Mode
Pulse Mode
Countdown Timer Settings
Count Down Enable
Down Counter Value
Multi-Screen Audio Source
Tick selection of Program or Preview audio on the HDMI outputs
Control Interface
Tick selection for ON or OFF
25
Tick selection for ON or OFF
Resets to factory default
Chosen input number
Tick selection for ON or OFF
Tick selection for ON or OFF
Each input can be selected
for Count Down ON or OFF.
If Count Down is ON then the
Down Counter value is set in
minutes and seconds
(MM:SS) - Max.= 1 Hour or
60:00, Default = 15 Seconds
or 00:15