Advertisement
Power loss during Sliding
Door operation
Sliding Door does not close
to primary latch position
Latch will not release from
primary position
Key fob or overhead
console switch does not
power operate sliding door
BCM or sliding door control module
critical fault codes
Failure of latch assembly
Failure of motor assembly
Binding or sticking of components
Wiring problems (system or vehicle)
Wiring problems (system or vehicle)
Battery voltage at PSDM is too low
<9.5V to start operation and
<8.0V to continue operation
Failure of Power Sliding Door or Body
Control Module
Failure of motor assembly
Door mis-alignment
Binding or sticking of components
Failure of Power Sliding Door or Body
Control Module
Sliding Door seal force too high
Failure of motor assembly
Not in Park or false indication
Battery voltage at PSDM is too low
Blown fuse
Failure of latch assembly
Failure of outside or inside handle
connection
Failure of Power Sliding Door or Body
Control Module
Binding or sticking of components
Blown Fuse
Battery voltage at PSDM is too low
Check for diagnostic trouble codes
Check wire connections and for blown fuse
Check for foreign matter preventing the
operation of latch assembly
Test motor assembly
Establish location of binding and replace
necessary components
Troubleshoot using electrical schematics
Refer to wiring diagrams
Troubleshoot using electrical schematics
Refer to wiring diagrams
Check for proper voltage at the PSDM.
Charge battery
Check for diagnostic trouble codes
Test motor assembly
Check latch and striker alignment
Check rollers and track alignment
Establish location of binding and adjust or
replace necessary components
Check for diagnostic trouble codes
Inspect seals for damage, mis-assembly,
foreign matter or other possible obstruction
Test motor assembly
Check switch status with SCAN tool
Check for proper voltage at the PSDM
Charge battery
Check fuse and replace if required
Check switch status with scan tool
Check for foreign matter or damaged
components preventing the operation of latch
assembly
Troubleshoot using body diagnostic manual.
Replace latch assembly, if necessary
Check handle connections on brainplate.
Check for diagnostic trouble codes.
Establish location of binding and adjust or
replace necessary components
Check fuse and replace
Check for proper voltage at the PSDM.
Charge battery
Refer to wiring diagrams
Advertisement
