System Boot-Up Num Lock; Numeric Processor Test; Floppy Drive Seek At Boot; Floppy Drive Swapping - AOpen AP43 User Manual

AMI BIOS

System Boot-up Num Lock

On
Setting this parameter to enables the numeric function of the
Off
numeric keypad. Set this parameter to to disregard the function.
Disabling the numeric function allows you to use the numeric keypad
On
for cursor control. The default setting is .

Numeric Processor Test

This parameter is non-configurable and auto-detected by the system.
If the CPU in use is a DX CPU, this parameter is automatically set to
Enabled
.
However, for the SX CPU, the setting is changed to
Disabled
.
This is because the SX CPU does not have an
integral numeric coprocessor.

Floppy Drive Seek at Boot

When enabled, the BIOS detects whether there is a floppy disk drive
installed. Disable the parameter to bypass the function.

Floppy Drive Swapping

This parameter allows you to swap floppy drives. For example, if you
have two floppy drives (A and B), you can assign the first drive as
drive B and the second drive as drive A or vice-versa. Disable the
Disabled.
parameter to bypass the function. The default is

System Boot-up Sequence

The settings are C:,A: and A:,C: to specify the system search
A:,C:
sequence. The default setting is
.
User's Guide
3-9