2.6.8
Silent Boot
This parameter enables or disables the Silent Boot function. When
set to
, BIOS is in graphical mode and displays only an
Enabled
identification logo during POST and while booting. After booting the
screen displays the operating system prompt (such as DOS) or logo
(such as Windows 95). If any error occurs while booting, the system
automatically switches to the text mode.
Even if your setting is
Enabled
while booting by pressing DEL when you see the " Enter Setup, Press
<DEL> Key " message on the screen.
When set to
, BIOS is in the conventional text mode where
Disabled
you see the system initialization details on the screen.
2.6.9
Num Lock After Boot
This parameter allows you to activate the Num Lock function upon
booting. The default setting is
2.6.10
Memory Test
When set to
Enabled
, this parameter allows the system to perform a
RAM test during the POST routine.
system detects only the memory size and bypasses the test routine.
The default setting is
Disabled.
2.6.11
Release All Blocked Memory
When set to Enabled, this parameter allows system to bypass testing
the defective memory banks detected earlier.
Setup Utility
, you may also switch to the text mode
.
Enabled
When set to
Disabled
, the
2-25