Hardware Setup
Turbo LED/Green Mode LED
You can use the J7 LED connector either for the Turbo function or for
the Green Mode function. However, you cannot use both functions at
the same time. To use the LED for turbo, you need to connect the
turbo switch into the CN5 multifunction connector. Take note that in
turbo mode, the LED is on. In deturbo mode, the LED is off.
To use the LED for the green function, you need to connect the break
switch into JP30 (i.e, the break switch connector). The green mode
LED is always on regardless of the system mode.
Keyboard Connector
The keyboard connector is a 5-pin, AT-compatible connector. The
following figure shows how to connect a keyboard.
User's Guide
2-22