Memory Speed (Dram); Cache Speed (Sram) - AOpen AP43 User Manual

The screen below appears if your Chipset Setup Mode parameter
Engineer
setting is
replaced the Memory Speed (DRAM) and the Cache Speed (SRAM)
parameters.
See screens 2, 3 and 4 for the rest of the parameters.
This manual describes only the End-user
setting parameters.

Memory Speed (DRAM)

This parameter lets you set the DRAM speed. The supported DRAM
speeds are 70 ns and 60 ns. The default setting is

Cache Speed (SRAM)

This parameter lets you set the SRAM cache speed. The supported
DRAM speeds are 15 ns and 20 ns. The default setting is
User's Guide
. Take note of the new parameters that
AMI BIOS
70 ns
.
20 ns
.
3-17