Power Link Function; Nmea Over Wlan Settings - Icom IC-M510 Instruction Manual

TRIAL MODE - Click here for more information
7. "Connection successful." is displayed when the
transceiver and the access point are connected.
8. Connect the access point and the CT-M500.
See steps 8 ~ 13 on page 90.
NOTE: The default gateway settings
• When the DHCP server function of the access point is set to "Enable," enter the default
gateway IP address.
• When you set your mobile device's IP address as the static IP address, set a default
gateway IP address of the mobile device.

■ Power Link function

You can set whether the CT-M500 is automatically turned
ON or OFF when the IC-M510 is turned ON or OFF.
Open the "Power Link" screen.
[MENU] > Settings > WLAN > Advanced Settings >
CT-M500 > Power Link
ON: The CT-M500 is linked so that when you turn
ON the IC-M510, the CT-M500 also turns ON
automatically.
OFF: The CT-M500 is not linked to the IC-M510.

■ NMEA over WLAN settings

You can output the NMEA 0183 (ver. 2.0 or later) sentence
through the Wireless LAN (WLAN).
[MENU] > Settings > WLAN > Advanced Settings >
NMEA over WLAN
Function
Select whether or not to connect to the NMEA 0183
network.
Destination IP
Enter the destination IP address in the NMEA network.
Destination Port
Enter the destination port number in the NMEA network.
11
WLAN SETTING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
92