Note; Precautions - Icom IC-M510 Instruction Manual

Hide thumbs Also See for IC-M510:
Table of Contents

Advertisement

TRIAL MODE - Click here for more information

Note

A WARNING STICKER is supplied with
the USA version transceiver.
To comply with FCC regulations, this sticker
readily seen from the operating controls
of the radio as in the diagram to the right.
Make sure the chosen location is clean and
dry before applying the sticker.

■ Precautions

R WARNING! NEVER connect the
transceiver directly to an AC outlet. This
R WARNING! NEVER connect the
transceiver to a power source of more
than 16 V DC such as a 24 V battery. This
the transceiver.
R WARNING! NEVER reverse the DC
power cable polarity. This could cause a
R WARNING! NEVER cut the DC power
cable between the DC power connector
on the transceiver's rear panel and the
fuse holder. If an incorrect connection is
made after cutting, the transceiver may be
damaged.
R WARNING! NEVER operate the
transceiver during a lightning storm. It may
damage the transceiver. Always disconnect
the power source and antenna before a
storm.
R WARNING! NEVER place the
transceiver where normal operation of the
vessel may be hindered, or where it could
cause bodily injury.
WARNING
STICKER
WARNING.
CAUTION: DO NOT place or leave the
transceiver in areas with temperatures
below –20°C ~ +60°C (–4ºF ~ +140ºF), or
in areas subject to direct sunlight, such as
a dashboard.
CAUTION: DO NOT use harsh solvents
This could damage the equipment
surfaces. If the surface becomes dusty or
dirty, wipe it clean with a soft, dry cloth.
BE CAREFUL! The transceiver's rear
panel will become hot when transmitting
continuously for long periods of time.
BE CAREFUL! The transceiver meets
IPX8 requirements for waterproof
protection*. However, once the transceiver
or microphone has been dropped,
or the waterproof seal is cracked or
damaged, waterproof protection cannot be
guaranteed because of possible damage to
the case or the waterproof seal.
* Except for the DC power connector,
NMEA In/Out leads and AF Out leads.
NOTE: Install the transceiver and/or
microphone more than 1 meter from the
vessel's magnetic navigation compass.
NOTE: Place the transceiver in a secure
place to avoid inadvertent use by
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
vi

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents