Table of Contents
Advertisement
Chapter 2
DDR Module Combination
To e nable normal operation, at least one DIMM mod ule sho uld be in-
stalled on the motherboard. You may install memory modules in the following
combination:
1. Support 64 MB, 128MB, 256 MB & 512 MB technologies for x8 & x16 devices
2. Supported devices must have 4 banks.
Installing DDR Modules
1. The DDR DIMM module has only one notch on the center.
Front View
2. Ins ert the DDR module v ertically into the DDR DIMM slo t. Make su re the
notch is on the rig ht orientation.
3. The plastic clips a t sides of the DIMM slot will automatically close.
Rear View
Volt
2-6
Power Supply
The mainboa rd supports ATX power supply for the power system. Be-
fore insertin g the power supply connec tor, always make sure th at all compo-
nents are installed properly to ensure that no damag e will be caused.
ATX 20-Pin Power Connector: ATX1
This connector allows you to connect to an ATX power supply. To con-
nect to th e ATX power s upply, make s ure th e plug s of th e power supply is
inserted in the proper orientation and the pins are alig ned. Then push down
the power su pply firmly into the con nector. The powe r connec tor supports
instant power on function which means that system will boot up immediately
when the power supply connector is inserted on the board.
ATX 12V Power Connector: JPW1
This 12V power connecto r is used to provide power to the CPU.
JPW1
JPW1 Pin Definition
Hardware Setup
ATX1
A TX1 Pin Definition
2-7
Advertisement
Table of Contents
