Hard Disk Connectors: Ide1 & Ide2; Cd-In Connector: Cdin1; Aux Line-In Connector: Cdin2; Modem-In Connector: Mdm_In1 - MSI MS-6552 Manual

Table of Contents

Advertisement

Chapter 2
Hard Disk Connectors: IDE1 & IDE2
The main board has a 32-b it En hanced PCI IDE and Ultra DMA 33/ 66/
100 controller that provides PIO mod e 0~4, Bus Maste r, and Ultra DMA/33/
66/100 func tio n. You can c onn ect up to four ha rd dis k d riv es, CD-ROM,
120MB Floppy (reserved for future BIOS) and other devices. These connec-
tors support the provided IDE hard disk cable.
IDE1 (Primary IDE Co nne cto r)
The firs t hard drive sh ould always be conn ected to IDE1. IDE1 can
connect a Master and a Slave drive. You must config ure se cond hard
drive to Slave mode by setting the jumpe r according ly.
IDE2 (Se conda ry IDE Co nnector)
IDE2 can also connect a Master and a Slave drive.
TIP:
If you in stall two h ard d isks o n cabl e, yo u must configure the
sec ond d rive to Sl ave mode b y sett ing i ts ju mper. Refe r to the
hard disk documentation supplied by hard disk vendors for jumper
setting instructions.
2-14

CD-In Connector: CDIN1

The co nnector is for CD-ROM audio conn ector.

Aux Line-In Connector: CDIN2

The c onnector is for DVD add-on card with Lin e-in conne ctor.
Modem-In Connector: MDM-IN1
The conn ector is for modem with inte rnal audio con nector.
MDM-IN1
CDIN1/CDIN2
Not e:
Mono-Out is connected to the Modem speaker-out connector.
Phone-In is connected to the Modem Microphone-In connector.
2-15
Hardware Setup

Advertisement

Table of Contents
loading

Table of Contents