Table of Contents
Advertisement
Safety Instructions
1.
Read the safety instructions carefully.
2.
Save this User' s Guide for possible use later.
3.
Keep this equipment away from humidity.
4.
Lay this equipment on a stable and flat surface before setting it up.
5.
The opening s on the enclosure are used for air convection and to prevent
the equipment from overheating . Note: Do not cover the opening s.
6.
Make sure that the power voltag e is within its safety rang e and has been
adjusted properly to the value of 110/220V before con necting the equip-
ment to the power inlet.
7.
Place the power cord in a way that people are unlikely to step on it. Do not
place anything on the power cord.
8.
Always unplug the power cord before inserting any add-on card or module.
9.
All cautions and warning s on the equipment should be noted.
10. Never pour any liquid into the opening that could damag e the equipment
or cause an electrical shock.
11. If any of the following situations arises, g et the equipment checked by a
service personnel:
?
the power cord or plug is damag ed
?
liquid has penetrated into the equipment
?
the equipment has been exposed to moisture
?
the equipment has not work well or you can not g et it work according
to User' s Guide
?
the equipment was dropped and damag ed
?
the equipment has obvious sig ns of breakag e
12. Do not leave theis equipment in an unco nditioned environmen t with a
sto rag e tempe rature of 60
0
C (140
equipment.
CAUTION: To pre ve nt explo sio n ca u se d b y impro per b a ttery
replacement, use the same or equivalent type of battery recommended
by the manufa cturer only.
0
F) or above , wh ich may dama g e the
iv
CONTE NTS
Chapter 1. Introduction ..................................................................................... 1-1
Mainboard Specification .............................................................................. 1-2
Mainboard Layout ........................................................................................ 1-4
Quick Components Guide ............................................................................ 1-5
Chapter 2. Hardware Setup .............................................................................. 2-1
Central Processing Unit: CPU...................................................................... 2-2
CPU Installation Procedures ................................................................ 2-2
CPU Core Speed Derivation Procedure .............................................. 2-4
Memory Installation ...................................................................................... 2-5
DDR Module Installation Procedures ................................................ 2-6
Power Supply ................................................................................................. 2-7
ATX 20-Pin Power Connector: ATX1 ................................................. 2-7
ATX 12V Power Connector: JPW1 ...................................................... 2-7
Back Panel ...................................................................................................... 2-8
Mouse Connector: KBMS1 .................................................................. 2-8
Keyboard Connector: KBMS1 ............................................................. 2-9
Audio Port Connectors ....................................................................... 2-10
Joystick/Midi Connectors .................................................................. 2-10
Parallel Port Connector: LPT1 ............................................................ 2-11
LAN Jack ............................................................................................... 2-12
USB Connectors .................................................................................. 2-12
Connectors ................................................................................................... 2-13
Floppy Disk Drive Connector: FDD1 ................................................ 2-13
IrDA Infrared Module Connector: IR1 ............................................. 2-13
Hard Disk Connectors: IDE1 & IDE2 ................................................ 2-14
CD-In Connector: CDIN1 .................................................................... 2-15
v
Advertisement
Table of Contents
