MSI MS-6552 Manual page 28

Chapter 3
1st/2nd/3rd Boot Device
The items allow you to set the sequence of boot devices where BIOS
attempts to load the disk operating system. The setting s are:
Floppy The system will boot from floppy drive.
LS120 The system will boot from LS-120 drive.
HDD-0 The system will boot from the first HDD.
SCSI The system will boot from the SCSI.
CDROM The system will boot from the CD-ROM.
HDD-1 The system will boot from the second HDD.
HDD-2 The system will boot from the third HDD.
HDD-3 The system will boot from the fourth HDD.
ZIP100 The system will boot from ATAPI ZIP drive.
LAN The system will boot from the Network drive.
Disabled Disable this sequence.
Boot Other Device
Setting the option to Enabled allows the system to try to boot from other
device if the system fails to boot from the 1st/2nd/3rd boot device.
Swap Floppy
Setting to Enabled will swap floppy drives A: and B:.
Seek Floppy
Setting to Enabled will make BIOS seek floppy drive A: before booting the
system. Setting s: Disabled and Enabled.
Boot Up Num-Lock LED
This item is to set the Num Lock status when the system is powered on.
Setting to On will turn on the Num Lock key when the system is powered on.
Setting to Off will allow end users to use the arrow keys on the numeric
keypad. Setting s: On and Off.
Gate A20 Option
This item is to set the Gate A20 status. A20 refers to the first 64KB of
extended memory. When Fast is selected, the Gate A20 is controlled by
Port92 or chipset specific method resulting in faster system performance.
3-10
When Normal is selected, A20 is controlled by a keyboard controller or
chipset hardware.
Typematic Rate Setting
This item is used to enable or disable the typematic rate setting including
Typematic Rate & Typematic Delay.
Typematic Rate (Chars/Sec)
After Typematic Rate Setting is enabled, this item allows you to set the rate
(characters/second) at which the keys are accelerated. Setting s: 6, 8, 10, 12,
15, 20, 24 and 30.
Typematic Delay (Msec)
This item allows you to select the delay between when the key was first
pressed and when the acceleration beg ins. Setting s: 250, 500, 750 and
1000.
Security Option
This specifies the type of BIOS password protection that is implemented.
Setting s are described below:
Option Description
Setup The password prompt appears only when end users try to
run Setup.
System A pa ssword prompt appe ars ev ery time whe n the com-
puter is powered on or when end users try to run Setup.
APIC Mode
This field is used to enable or disable the APIC (Advanced Prog rammable
Interrupt Controller). Due to compliance to PC2001 desig n g uide, the system
is able to run in APIC mode. Enabling APIC mode will expand available IRQs
resources for the system. Setting s: Enabled and Disabled.
MPS Version Control For OS
This field allows you to select which MPS (Multi-Processor Specification)
version to be used for the operating system. You need to select the MPS
version supported by your operating system. To find out which version to
3-11
AWARD BIOS Setup
®