To Remove The Pipe Port Cover - Daikin FAA71BUV1B Installer And User Reference Manual

16.3.3 To remove the pipe port cover

FAA71+100BUV1B
Split system air conditioner
4P654517-1 – 2021.03
3 Insert a wall cover into the wall pipe.
a b
c
a Wall embedded pipe (field supply)
b Putty (field supply)
c Wall hole cover (field supply)
4 After completing wiring, refrigerant piping and drain piping, do NOT forget to
seal the gap with putty.
INFORMATION
To connect the piping on right-side, right-bottom, left-side or left-bottom, the pipe
port cover MUST be removed.
b
a
a Cut off for side piping
b Cut off for bottom piping
1 Remove the front grille
2 Cut off the pipe port cover from inside the front grille using a coping saw.
3 Remove any burrs along the cut section using a half round needle file.
NOTICE
Do NOT use nippers to remove the pipe port cover, as this would damage the front
grille.
("16.2.3 To remove the front
16 Unit installation
|
4
grille" [ 52]).
Installer and user reference guide
57