Stx Kaw Write Data To Rfid Tag; Interface); Stx Kb Backfeed Time Delay - Datamax A-4310 Programmer's Manual

STX KaW Write Data to RFID Tag

(Direct Mode – Generic Read/Write Interface)
This command instructs the RFID device to write data to the tag. It is expected that the tag
transponder will be within the read / write distance of the RFID programming device; otherwise, a
warning will occur and a warning message (Read / Write Fail) will be displayed.
Syntax:
Where:
Sample:
The sample writes the data "TEST" at block zero.
* Dependent on transponder manufacturer.
STX Kb Backfeed Time Delay
(Non-Display Models only)
The backfeed time delay command controls the time a printed label is allowed to remain "presented"
before being retracted to the start of print position.
Syntax:
Where:
40
Extended System-Level Command Functions
<STX>KaWAaaabbbcdee...e<CR>
- Optional – for data in the ASCII format, followed by the byte
Aaaa
count (000-999).
- HF – Starting block number (000
bbb
UHF – Should be 000.
- Command 1. Reserved for Future (should be 0)
c
- Command 2. Reserved for Future (should be 0)
d
- Data to be encoded on RFID tag (HF – the last used block will be
ee...e
null-padded, if necessary).
Note: UHF ASCII formats must be 8 or 12 characters; and, UHF
Hexadecimal formats must be 16 or 24 character pairs.
<STX>KaW0000054455354[CR]
<STX>Kbnnn<CR>
- Seconds/10
nnn
maximum block number).*
Class Series Programmer's Manual