Stx Kn Nic Reset; Stx Ko Gpio Output - Datamax A-4310 Programmer's Manual

STX Kn NIC Reset
This command resets the NIC to factory defaults.
Syntax:
Where:
STX KO GPIO Output
This command configures the GPIO output channels of the Applicator Interface Card; see Appendix J
for details.
Syntax:
Where:
Class Series Programmer's Manual
Extended System-Level Command Functions
<STX>Knx
- Specifies the action to take, where:
x
F = Returns the NIC to the factory default settings; and,
H = Reports settings to host (wireless, only).
Address
IP
Subnet
Mask
Gateway
* Prior to introduction of the WiFi, 192.0.0.192 was the IP default
value and the Subnet Mask was 0.0.0.0.
<STX>KOffnsptd0pw0td1pw1<cr>
- 2 character function name abbreviation (e.g., LC [Label
ff
Complete], LM [Label Movement], etc).
- Pin number, where 1 – 8 is the valid range.
n
- Signal type, where: L = Level; P = Positive Pulse; and N =
s
Negative Pulse
- Polarity, where: 0 = Active Low; and 1 = Active High
p
- 3 character delay time from function condition "true" to
td0
output signal.
- 3 character pulse width corresponding to the function
pw0
condition becoming "true". (Ignored for level-type signals.)
- 3 character delay time from function condition "false" to
td0
output signal.
- 3 character pulse width corresponding to the function
pw0
condition becoming "false". (Ignored for level-type signals.)
Default Values
Wired *
192.168.010.002
255.255.255.000
000.000.000.000
Default Values
WiFi
192.168.010.001
255.255.255.000
000.000.000.000
95