Set Count By Amount; Special Label Formatting Command Functions - Datamax A-4310 Programmer's Manual

^

Set Count By Amount

This command allows applications using the increment / decrement field command to print more than
one label with the same field value before the field data is updated. All printers default to 1.
Note: This command can only be issued once per label format. In addition, when alternate Control Codes
are enabled, the ^ character must be replaced by the @ character (hexadecimal 0x40). See
Control Codes.
Syntax:
Where:
Sample:
The sample prints two labels containing the same field value before decrementing the field. Six labels
are printed.

Special Label Formatting Command Functions

Two Special Label Formatting Commands, the <STX>S and the <STX>T, are entered directly into the
data field of label format records. Do not confuse them with System-Level Commands because the same
control character is used. If alternate control codes are enabled the <STX> becomes '~' (hexadecimal
0x7E); see Control Codes.
Label Formatting Character
<STX>S
<STX>T
Class Series Programmer's Manual
Label Formatting Command Functions
^nn
- May be 0x55 or 0x40; see Control Codes.
^
- Is a two-digit value that specifies the number of labels to be
nn
generated before incrementing (or decrementing) the field value.
<STX>L<CR>
13220000000000012345<CR>
-01<CR>
^02<CR>
Q0006<CR>
E<CR>
Table 6-2: Special Label Formatting Commands
Command Description
Recall global data and place in field
Print time and date
125