Table of Contents
Advertisement
net wlan
P
URPOSE
The
variable is used for working with wireless network (WLAN)
net wlan
settings in the following ways:
• Configuring your NetDefend firewall's WLAN settings, including:
• Hide Network Address Translation (NAT)
• The WLAN network's default gateway
• The WLAN network's internal network range
• DHCP (Dynamic Host Configuration Protocol) settings
• Secure HotSpot access
• Displaying and exporting the above WLAN network settings
• Displaying and exporting all WLAN network settings, including WLAN
High Availability settings.
For information on configuring, displaying, and exporting specific WLAN High
Availability settings, see net wlan ha on page 225.
When using wireless NetDefend models, you can define a wireless internal
network called a WLAN network.
For information on configuring wireless connection settings, including the
operation mode, security settings, and wireless transmitter settings, see wireless on
page 404. For information on default security policy rules controlling traffic to and
from the WLAN, refer to the User Guide.
This variable is only relevant for models supporting a wireless interface.
Note: It is recommended to configure the WLAN via Ethernet and not via a wireless
connection, because the wireless connection could be broken after making a change
to the configuration.
Chapter 5: CLI Variables
net wlan
219
Advertisement
Table of Contents
