Table of Contents
Advertisement
Chapter 2
You can connect a console to the NetDefend firewall, and use the console to
control the appliance via the command line.
Note: Your terminal emulation software must be set to 57600 bps, N-8-1.
To run commands using a console
1. Connect the serial console to your NetDefend firewall's serial port, using an RS-
232 Null modem cable.
2. Log on to the NetDefend Portal.
For instructions, refer to the User Guide.
3. Click Network in the main menu, and click the Ports tab.
The Ports page appears.
4. In the RS232 drop-down list, select Console.
5. Click Apply.
You can now control the NetDefend firewall from the serial console.
Chapter 2: Using the Serial Console
Using the Serial Console
Related Publications
5
Advertisement
Table of Contents
