Hotspot - D-Link NetDefend DFL-CP310 Cli Reference Manual

hotspot

P
URPOSE
The variable is used for working with Secure HotSpot settings in the

hotspot

following ways:
• Configuring Secure HotSpot settings
• Displaying and exporting Secure HotSpot settings
You can enable your NetDefend firewall as a public Internet access hotspot for
specific networks. When users on those networks attempt to access the Internet,
they are automatically re-directed to the My HotSpot page http://my.hotspot. On
this page, they must read and accept the My HotSpot terms of use, and if My
HotSpot is configured to be password-protected, they must log on using their
NetDefend username and password. The users may then access the Internet.
For information on enabling Secure HotSpot for specific networks, see net dmz on
page 168, net lan on page 181, and net wlan on page 219.
For information on granting HotSpot access to users, see users on page 345.
You can choose to exclude specific network objects from HotSpot enforcement.
For information, see netobj on page 226.
Important: SecuRemote VPN software users who are authenticated by the Internal
VPN Server are automatically exempt from HotSpot enforcement. This allows, for
example, authenticated employees to gain full access to the corporate LAN, while
guest users are permitted to access the Internet only.
Note: HotSpot enforcement can block traffic passing through the firewall; however, it
does not block local traffic on the same network segment (traffic that does not pass
through the firewall).
S
YNTAX
When used with
set
set hotspot [title title] [terms terms] [auth auth] [multiplelogin multiplelogin]
[usehttps usehttps]
Chapter 5: CLI Variables
:
hotspot
159