Table of Contents
Advertisement
Crestron TPS-4500 & TPS-4500L
Operations Guide - DOC. 5891A
Touchpanel Mounting Options for TPS-4500L
Back Box Mounting
Back box mounting is typically used at new construction sites. The optional back
box, BB-5000, includes the necessary hardware, brackets and electrical box, which
provides a secure enclosure that, can be fastened directly to a stud. The details for
this optional mounting method are provided in the latest revision of the BB-5000
Installation Guide (Doc. 5827). After completing the steps in the installation guide,
simply mate the four posts of the bezel with the holes drilled into the mounting
surface and firmly press the bezel over the touchpanel.
NOTE: The mounting hardware and accessories supplied with the TPS-4500L are
not required for the back box mounting option.
Direct Mounting
The TPS-4500L is a low-voltage unit that can be installed directly into a mounting
surface. Each touchpanel is provided with mounting hardware and accessories, as
shown in the table after this paragraph.
TPS-4500L Supplied Mounting Hardware and Accessories
ITEM
Large Metal Mounting Plate
Small Metal Mounting Plate
Template
Screw, Pan Phillips
Connector
NOTE: For cutout dimensions, refer to "Appendix B: Cutout Detail of Supplied
Template" on page 43.
Complete the following installation procedure in the order provided. The only tools
required are a gypsum board saw (or equivalent), a #2 Phillips tip screwdriver, a
drill, a 5/16" bit, and a #20 bit. Complete the following installation procedure in the
order provided.
1. Locate an area on the wall that is free of miscellaneous wiring and
studs.
2. Make a small hole near the middle of the designated site; verify that the
location is suitable.
3. Fasten cutout template (40049, supplied) to mounting surface; verify
that the template is level.
4. Cut out and remove the traced shape of the mounting surface.
5. Drill four 5/16" holes as marked on template. Refer to "Appendix B:
Cutout Detail of Supplied Template" on page 43 for an illustrative
reference.
6. Drill 12 holes marked "A" on template with #20 bit. Refer to
"Appendix B: Cutout Detail of Supplied Template" on page 43 for an
illustrative reference.
12 Inch Tilt/Lectern Touchpanels: TPS-4500 & TPS-4500L • 19
12 Inch Tilt/Lectern Touchpanels
PART NUMBER
MTPL02553-1
MTPL02523-1
OV40049-1
#6-32 x 1" LG
JHPS197SG04SR-2
QUANTITY
2
2
1
12
1
Advertisement
Table of Contents
