Crestron Isys TPS-4500 Operation Manual page 22

12 Inch Tilt/Lectern Touchpanels
18 • 12 Inch Tilt/Lectern Touchpanels: TPS-4500 & TPS-4500L
that is required to protect the equipment. Using non-Crestron cables will result in
damage to the product.
This 10-pin RJ-45 port provides network connection from the touchpanel to the
interface module and network power to the touchpanel. This port also contains the
composite and S-video connections if a TPS-VID-1 or TPS-VID-2 is installed in the
TPS-4500. Refer to the descriptions and pinout table that follow this paragraph.
Pin Assignments
TYPE PIN DESIGNATION
1
10-pin RJ-45
Pin 1
Pin 1
2
3
4
5
6
7
8
9
10
To determine the location of pin 1, hold the cable so that the end of the 10-pin RJ-45
connector is facing away from you, with the clip side down and the copper side up.
The copper connector on the far left is pin 1.
NOTE: When using the TPS-VID-1 or TPS-VID-2, pins 3, 4, 7, and 8 are used to
transmit video signals from the touchpanel interface to the TPS-4500. Consult the
latest revision of the TPS-VID-1/VID-2 Operations & Installation Guide (Doc. 6059)
for details.
24 VDC, 2.0A (Power Supply for TPS-4500)
This female connector is used to supply 24 VDC power to the TPS-4500 or the
TPS-4500IMPC from an optional power pack (Crestron model PW-2420RU). When
power is supplied to the TPS-4500IMPC through this connector, a Cresnet power
connection is not required to display video on the touchpanel (if a video card is
installed in the TPS-4500).
CAUTION: Use only Crestron power supplies for Crestron equipment. Failure to
do so could cause equipment damage or void the Crestron warranty.
CAUTION: If power is provided to the TPS-4500 from the +24VDC on a Cresnet
connector or the optional PW-2420RU to the touchpanel base, power must not be
applied to the power input on the TPS-4500IMPC.
NOTE: Use care in wiring installations to avoid applying 24 VDC power to Cresnet
wiring from multiple sources.
Crestron TPS-4500 & TPS-4500L
DESCRIPTION
+24V Power (Network)
GND Ground (Network)
C+ Chrominance (Positive) /Composite 2
C- Chrominance (Negative) /Composite 2
Y Data (Network)
Z Data (Network)
Y+ Luminance (Positive)/Composite 1
Y- Luminance (Negative)/Composite 1
GND Ground (Network)
+24V Power (Network)
Operations Guide - DOC. 5891A