Table of Contents
Advertisement
12 Inch Tilt/Lectern Touchpanels
20 • 12 Inch Tilt/Lectern Touchpanels: TPS-4500 & TPS-4500L
Crestron TPS-4500 & TPS-4500L
7. Slide one large metal mounting plate through the opening and position
it inside along the top horizontal edge.
8. Position one small metal mounting plate along the top horizontal edge
so that it covers the two center holes marked "A".
9. Use two pan head screws, supplied, to secure the bracket and plate to
the mounting surface. Tighten by hand; do not fully tighten screws.
Securing Two Plates to Top and Bottom Edges of Opening
LARGE
METAL
MOUNTING
PLATE
MOUNTING
DRYWALL
10. Repeat steps 7 through 9 for the bottom horizontal edge of the opening.
11. Attach the network cable and other cables (i.e., RS-232 or video) in the
wall to the appropriate connector on the back of the touchpanel. Refer
to "Network Wiring" on page 9 for network wiring details. Information
about the RS-232 connector is located in "RS-232" on page 16. For
wiring the video connector, refer to the latest version of the
TPS-VIDL-1/2 Operations & Installation Guide (Doc. 6070).
12. Position the touchpanel (less the faceplate) into the opening and secure
with eight pan head screws, supplied. Tighten by hand; do not fully
tighten screws.
Positioning Touchpanel into Opening
POSITION
AND SECURE
TOUCHPANEL
INTO OPENING
NOTE:
WIRING NOT SHOWN
FOR CLARITY
DRYWALL
SMALL
TWO PAN
METAL
HEAD
SCREWS
PLATE
(MOUNTS PLATES
IN TWO CENTER
TAPPED HOLES)
Operations Guide - DOC. 5891A
Advertisement
Table of Contents
