Table of Contents
Advertisement
12 Inch Tilt/Lectern Touchpanels
16 • 12 Inch Tilt/Lectern Touchpanels: TPS-4500 & TPS-4500L
NET
This 4-pin Cresnet connector provides Cresnet network connection from the
touchpanel as well as power to the touchpanel. A description of the pinouts is shown
in the table after this paragraph. Refer to "Network Wiring" on page 9 for details.
NET Pinouts
PIN #
DESIGNATION
1
24
2
Y
3
Z
4
G
RS-232
This 6-pin RJ-11 connector mates with a serial port of a PC. The connecting cable is
not supplied. Prior to installation, use this port for direct connection between the
touchpanel and a PC to load files to a touchpanel without a network connection. In
the event that modular cables or an RJ-11 to DB9F adapter is not available, the table
below and diagram on the next page provide information so that the cable can be
fabricated on site. Refer to "RS-232 Menu" on page 13 for proper RS-232 port
configuration settings. Also refer to "Appendix A: RS-232 Protocol" on page 41 for
protocol details.
RS-232 Pinouts
PIN #
DESCRIPTION
1
CTS
2
GND
3
RXD
4
TXD
5
RTS
6
N/C (Not connected)
PC to TPS-4500/L Cable Specifications (Crestron Cable Number STCP-502PC)
Other Connections
When using the TPS-VIDL-1 or TPS-VIDL-2, three connectors are provided for
supplying a video source and are active with the purchase and installation of the
TPS-VIDL-1 or TPS-VIDL-2 video module card. Consult the latest revision of the
TPS-VIDL-1/VIDL-2 Operations & Installation Guide (Doc. 6070) for details.
Crestron TPS-4500 & TPS-4500L
DESCRIPTION
Power
Data
Data
Ground
1
6
Top
Front
1
6
Operations Guide - DOC. 5891A
Advertisement
Table of Contents
