HP ProLiant DL145 Maintenance And Service Manual page 71

Recoverable POST Errors
Whenever a non-fatal error occurs during POST, an error message describing the problem
appears onscreen. These text messages are displayed in normal video (white text on black
background). It shows the details of the error. The following is an example of a POST error
message:
In some cases an error message may include recommendations for troubleshooting or require
that you press the Enter key to display recommendations. Follow the instructions on the
screen.
Table 3-4 lists down the most common POST error messages with their corresponding
troubleshooting recommendation. It is recommended that you correct the error before
proceeding, even if the server appears to boot successfully.
If your system displays one of the messages marked below with an asterisk (*), write down
the code and message and contact your HP Customer Support provider.
When no POST error message is displayed but the server stops during POST, listen for beep
codes.
Table 3-4: POST Error Messages
Error code Error message
0200 Failure Fixed Disk
0210 Stuck key
Mouse error
0211 Keyboard error
HP ProLiant DL145 Generation 2 Server Maintenance and Service Guide
All manuals and user guides at all-guides.com
Error message 1 of 1:
Keyboard not detected - Keyboard error
Description/corrective action
Fixed disk is not working or not configured properly.
1.
2.
Stuck key on keyboard.
1.
2.
Mouse not working.
Verify the mouse cable is securely connected to the mouse port
(not the keyboard port) on the rear panel of the server.
If the problem persists, replace the mouse or contact your HP
Customer Support provider.
Keyboard not working.
Verify that the keyboard cable is securely connected to the
keyboard port (not the mouse port) on the rear panel of the server.
If the problem persists, replace the keyboard or contact your HP
Customer Support provider.
Error code 0103
Run Setup and check if the fixed-disk type is correctly
identified.
Check to see if fixed disk is attached properly.
Locate the stuck key on your keyboard and release it.
Reboot the server.
Diagnostic Tools
continued
3-13