HP ProLiant DL145 Maintenance And Service Manual page 26

Removal and Replacement Procedures
Configuring a SCSI Hard Drive:
The steps listed below give an overview of the SCSI hard drive configuration procedure:
1. Install the SCSI hard drive.
2. Install the SCSI controller board.
3. Route the SCSI drive cables.
4. Set up the SCSI configuration.
Refer to the documentation that came with the SCSI controller board for detailed
procedures.
To install a SCSI hard drive:
1. Perform the pre-installation procedures described on page 2-5.
2. Select which drive bay you will use to install the new hard drive.
If the desired drive bay is occupied, remove the currently installed drive following the
procedures described on page 2-14.
If the desired drive bay is empty, perform step 3 of the "To remove a hard drive" section
on page 2-15, then remove four mounting screws from the HDD carrier. You will use
these screws to install the new drive.
3. Install the new SCSI hard drive in its carrier:
If you are installing the new drive in a previously occupied drive bay, use the HDD
carrier and mounting screws you removed from the old drive.
If you are installing the new drive in an empty drive bay, use the HDD carrier and
mounting screws you removed from that drive bay.
a. Align the new hard drive on the carrier.
b. Secure the hard drive assembly with the four mounting screws.
c. Slide the hard drive assembly into the chassis.
2-16
All manuals and user guides at all-guides.com
HP ProLiant DL145 Generation 2 Server Maintenance and Service Guide