HP ProLiant DL145 Maintenance And Service Manual page 45

Figure 2-40: Removing a memory module
6. Place the memory module on a static-dissipating work surface or inside an anti-static bag.
To install a memory module:
1. Perform steps 1 through 3 of the "To remove a memory module" section.
2. Locate an empty DIMM slot on the system board.
3. If necessary, open the holding clips of the selected DIMM slot.
4. Remove the memory module from its protective packaging, handling it by the edges.
5. Install the memory module:
a. Orient the module so that the notch on its bottom edge aligns with the keyed surface
b. Firmly press the holding clips inward to secure the memory module in place.
Figure 2-40: Installing a memory module
6. Perform the post-installation procedures described on page 2-6.
HP ProLiant DL145 Generation 2 Server Maintenance and Service Guide
All manuals and user guides at all-guides.com
of the DIMM slot, and then press it fully into the slot.
The DIMM slots are structured to ensure proper installation. If you insert a memory
module but it does not fit easily into the slot, you may have inserted it incorrectly.
Reverse the orientation of the module and insert it again.
If the holding clips do not close, the module is not inserted correctly.
Removal and Replacement Procedures
2-35