Phoenixbios Setup Utility - HP ProLiant DL145 Maintenance And Service Manual

PhoenixBIOS Setup Utility

NOTE: For ease of reading, PhoenixBIOS Setup Utility will be simply referred to as "Setup" or "Setup
Utility" in this guide.
NOTE: The screenshots used in this guide display default system values. These values may not be the
same those in your server.
PhoenixBIOS Setup Utility is a hardware configuration program built into your system's
Basic Input/Output System (BIOS). Since most systems are already properly configured and
optimized, there is normally no need to run this utility.
You will need to run this utility under the following conditions:
•
When changing the system configuration including:
— Setting the system time and date
— Configuring the hard drives
— Specifying the boot device sequence
— Configuring the power management modes
— Setting up system passwords or making other changes to the security setup
•
When a configuration error is detected by the system and you are prompted ("Run Setup"
message) to make changes to the BIOS settings.
NOTE: If you repeatedly receive "Run Setup" messages, the battery located on the system board (BT1)
may be defective. In this case, the system cannot retain configuration values in CMOS. Ask a qualified
technician for assistance.
The Setup Utility loads the configuration values in a battery-backed nonvolatile memory
called CMOS RAM. This memory area is not part of the system RAM, which allows
configuration data to be retained when power is turned off. The values take effect when the
system is booted. POST uses these values to configure the hardware. If the values and the
actual hardware do not agree, POST generates an error message. You must run this utility to
change the BIOS settings from the default or current configuration.
HP ProLiant DL145 Generation 2 Server Maintenance and Service Guide
All manuals and user guides at all-guides.com
Diagnostic Tools
3-3