HP ProLiant DL145 Maintenance And Service Manual page 36

Removal and Replacement Procedures
To install a SATA hard drive:
1. Install the SATA hard drive following the procedures described in the "To install a SCSI
hard drive" section on page 2-16.
2. Route the SATA drive cables:
a. Route the SATA and power cables through the cable management opening of the
b. Connect the SATA and power cables to their corresponding connectors on the rear of
c. Check that all cables are clear of the hard drive carrier and are properly routed to
Figure 2-30: Routing the SATA drive cables
3. Perform the post-installation procedures described on page 2-6.
4. Set up the SATA configuration.
For detailed procedures, refer to the Server Support CD or to the operating system
documentation.
2-26
All manuals and user guides at all-guides.com
chassis' partition wall.
the new drive.
their corresponding connectors, then tighten the screw that secures the hard drive
assembly to the chassis.
HP ProLiant DL145 Generation 2 Server Maintenance and Service Guide