Assembly; Table; Rear Support - Grizzly T30945 Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
Serious injury could occur if you connect
machine to power before completing setup
process. DO NOT connect to power until
instructed later in this manual.
To assemble machine:
1. Attach rear support to back of saw with (2)
pre-installed wing knob bolts (see Figure 6).
x 2
Figure 6. Rear support installed.
2.
Lift and remove bevel table.
3. Install blade as instructed in Removing &
Installing Blade on Page 24.
-14-

Rear Support

4. Remove (3) pre-installed flange screws
shown in Figure 7.
Figure 7. Splash hood flange screws location.
5.
Attach splash hood assembly to table with
flange screws so blade guard rests over
blade (see Figure 8).
6. Loosen splash hood lock knob (see Figure 8)
and adjust hood until it is aligned with but does
not contact blade, then tighten to secure.
Splash Hood
Figure 8. Splash hood attached to table.
7. Insert overflow drain plug into hole at bottom
of water bath and push firmly to secure (see
Figure 9).
Overflow
Drain Plug
Figure 9. Overflow drain plug installed.
Model T30945 (Mfd. Since 12/19)
x 3
Splash Hood
Lock Knob

Table