Making Bevel Cuts - Grizzly T30945 Owner's Manual

3. Unlock rip fence by lifting rip fence lock lever,
adjust to desired cut width on scale, and push
lock lever down to secure (see Figure 24).
Rip Fence
Lock Lever
Figure 24. Rip fence lock lever location.
4.
Position tile flush against miter guide at front
of saw.
5.
Loosen splash hood lock knob and adjust
hood to height of tile (see Figure 25). Hood
should be as close to tile as possible without
touching.
Splash Hood
Lock Knob
Figure 25. Splash hood lock knob location.
6. Connect machine to power and turn ON.
Model T30945 (Mfd. Since 12/19)
7. Ensure blade is wet, then push tile through
cut (see Figure 26).
Top view
Figure 26. Tile ready for miter cut.

Making Bevel Cuts

The bevel table allows for bevel cuts when adjust-
ed up at a tilt. The two support legs have stops
at 22.5˚ and 45˚ for easy adjustment to common
bevel cuts.
To make a bevel cut:
1. DISCONNECT MACHINE FROM POWER!
2. Unlock and remove rip fence and attached
miter guide from saw table.
3. Tilt bevel table up and adjust insert table legs
to desired angle stop (see Figure 27).
Figure 27. Bevel table set to 45˚.
Tile
Table Legs
-21-