Making L-Cuts - Grizzly T30945 Owner's Manual

4. Position tile against tilted table at front of saw.
5. Loosen splash hood lock knob and adjust
hood to height of tile (see Figure 28). Hood
should be as close to tile as possible without
touching.
Splash Hood
Lock Knob
Figure 28. Splash hood lock knob location.
6. Connect machine to power and turn ON.
7.
Ensure blade is wet, then push tile through
cut with a push stick or some other type of
workpiece support (see Figure 29).
Top View
Figure 29. Tile ready for bevel cut.
-22-
Tile
Front View

Making L-Cuts

For corners and other tough-to-fit places, you may
need to make an L-cut, or make two separate cuts
that do not extend the full length of the tile, as
shown in Figure 30.
L-Cut Tile
Figure 30. Example of an L-cut.
To make an L-cut:
1. DISCONNECT MACHINE FROM POWER!
2. Mark bottom of tile with area to be cut.
3. If making an angled cut, loosen miter guide
lock knob, adjust to desired miter angle, and
tighten to secure (see Figure 31). If rip cut-
ting, remove miter guide.
Miter Guide
Lock Knob
Figure 31. Miter guide lock knob location.
Model T30945 (Mfd. Since 12/19)
Wall Corner