Squaring Fence To Blade - Grizzly T30945 Owner's Manual

Squaring Fence to
Blade
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
The following procedure aligns the rip fence par-
allel to the blade. Once the fence is adjusted, the
bracket holding the blade to the table must also
be aligned.
Items Needed
Phillips Screwdriver #2 ...................................... 1
To square fence to blade:
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen splash hood lock knob, lift hood
fully, and tighten lock knob to secure (see
Figure 46).
Splash Hood
Lock Knob
Figure 46. Splash hood lifted for fence
adjustment.
3. Remove miter guide.
-30-
4.
Position rip fence so indicator reads 0" (see
Figure 47) and lock in place.
5. Loosen both screws shown in Figure 47.
Figure 47. Rip fence adjustment screw locations.
6. Adjust rip fence until it barely contacts blade.
There should be no gaps between blade and
Qty
fence.
7. Tighten screws loosened in Step 5.
8. Remove bevel table.
9. Loosen (3) screws shown in Figure 48.
Figure 48. Splash hood mounting screw
x 2
Indicator
x 3
locations.
Model T30945 (Mfd. Since 12/19)