Table of Contents
Advertisement
SECTION 6: MAINTENANCE
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
Schedule
For optimum performance from this machine, this
maintenance schedule must be strictly followed.
Ongoing
To maintain a low risk of injury and proper
machine operation, if you ever observe any of the
items below, shut down the machine immediately
and fix the problem before continuing operations:
•
Loose mounting bolts.
•
Damaged blade.
•
Worn or damaged wires.
•
Any other unsafe condition.
Weekly Maintenance
•
Replace bath with fresh water.
•
Clean table, rip fence, and miter guide.
•
Check wear on blade and dress or replace as
necessary.
Monthly Check
•
Thoroughly clean water bath.
Model T30945 (Mfd. Since 12/19)
Cleaning &
Protecting
Cleaning the Model T30945 is relatively easy.
Wipe off tile dust with a wet cloth. If dust has built
up in the bath or splash hood, use a mild soap
and warm water to remove it.
Protect the unpainted portions of the table by wip-
ing it clean after every use—this ensures moisture
from operations does not remain on bare metal
surfaces.
Lubrication
Sealed and pre-lubricated ball bearings require
no lubrication for the life of the bearings. All bear-
ings are standard sizes, and replacements can be
purchased from our parts department or a bearing
supply store.
Dressing Blade
The abrasive blade can dull over time but cannot
be sharpened like a normal saw blade. The abra-
sive material of the blade can become covered by
adhesive material, dulling the blade prematurely.
Dressing the blade can re-expose the abrasive
and effectively "sharpens" the blade.
To dress the blade, slowly cut into a dressing
stone, as you would a tile, until the entire band
of abrasive passes through the stone. Repeat as
necessary.
-27-
Advertisement
Table of Contents
