Grizzly T30945 Owner's Manual page 25

4. Unlock rip fence by lifting rip fence lock lever,
adjust to first cut width on scale, and push
lock lever down to secure (see Figure 32).
Rip Fence
Lock Lever
Figure 32. Rip fence locked for first cut.
5.
Position tile against rip fence at front of saw.
6.
Loosen splash hood lock knob and adjust
hood to height of tile (see Figure 33). Hood
should be as close to tile as possible without
touching.
Blade Guard
Lock Knob
Figure 33. Splash hood lock knob location.
7. Connect machine to power and turn ON.
Model T30945 (Mfd. Since 12/19)
8. Ensure blade is wet, then push tile through
cut until you contact second line drawn in
Step 2 (see Figure 34).
Stop
Line
Top view
Figure 34. First cut complete.
9. Without removing tile, turn saw OFF.
10. Wait for blade to stop spinning, then remove
tile.
11. Adjust rip fence for width of second cut and
lock to secure.
12. Turn saw ON and make second cut, cut-
ting until contacting first cut (see Figure
35). When contacted, cut-off piece should
separate.
Tile
Top view
Figure 35. Second cut complete.
13. Without removing tile, turn saw OFF.
14. Wait for blade to stop spinning, then remove
tile.
Tile
Cut-Off
Piece
-23-