Table of Contents
Advertisement
7. Module reference: Oscillator group
F F F F
I I I I N N N N E E E E
Sets the fine tuning of the oscillator. The range is +/- half a semitone divided into 128 steps. Click on the
triangle above the control to reset the fine tuning to 0, which is the preset value.
P P P P
I I I I T T T T C C C C H H H H M M M M O O O O D D D D U U U U L L L L A A A A T T T T I I I I O O O O N N N N I I I I N N N N P P P P U U U U T T T T S S S S
There are two blue modulation inputs for modulating the oscillator pitch on this module. The modula-
tion amount is attenuated with the rotary knob next to each input. See
for more info.
KBT
KBT
KBT
KBT
KBT is the hardwired connection between the oscillator and the keyboard (and the MIDI input). If KBT
is activated the oscillator will track the keyboard at the rate of one semitone for each key. If KBT is not
activated, the keyboard will not affect the oscillator frequency.
O O O O
A A A A
S S S S C C C C
This oscillator can produce one of four waveforms: Square/Pulse, Sawtooth, Triangle or Sine. The oscil-
lator has two pitch modulation inputs, one frequency modulation (FMA) input, a sync input and an in-
put to modulate the width of the Pulse wave.
F F F F
R R R R E E E E Q Q Q Q D D D D I I I I S S S S P P P P L L L L A A A A Y Y Y Y B B B B O O O O X X X X
Click on the display box switch between Hz and Notes. Range: C-1 to G9 (7.94 Hz to 12910 Hz).
S S S S
L L L L V V V V O O O O U U U U T T T T P P P P U U U U T T T T
This is a gray control output for controlling the pitch of a slave oscillator. Patch this output to a Mst input
on a slave module. If you control a slave LFO with this signal, the pitch of the LFO will be 5 octaves
below the pitch of the master oscillator.
C C C C
O O O O A A A A R R R R S S S S E E E E
Sets the coarse tuning of the oscillator. Range: C-1 to G9 (8.18 Hz to 12540 Hz).
F F F F
I I I I N N N N E E E E
This control fine-tunes the oscillator. The range is +/– half a semitone, divided into 128 increments.
Click on the triangle above the control to reset the fine-tuning to 0, which is the preset value.
KBT
KBT
KBT
KBT
This is the hardwired connection between the oscillator and the keyboard. At the Key value, the oscillator
will track the keyboard at the rate of one semitone for each key. Turning the KBT control to the maxi-
mum clockwise position (2.0) will produce a two-octave span from one octave on the keyboard, a value
of 0.50 will produce a one octave span from two octaves played on the keyboard. Off removes the key-
board tracking completely. Click on the triangle above the knob to reset the KBT setting to Key, which
is the preset value.
Page 100
[A
[A
[A
[A
T T T T
II]
II]
II]
II]
T T T T T T T T E E E E N N N N U U U U A A A A T T T T O O O O R R R R
Y Y Y Y P P P P E E E E
NORD MODULAR V3.0
"Pitch modulation" on page 34
Advertisement
Table of Contents
