Table of Contents
Advertisement
NORD MODULAR V3.0
4. Basic functions
E E E E
D D D D I I I I T T T T P P P P A A A A R R R R A A A A M M M M E E E E T T T T E E E E R R R R S S S S I I I I N N N N A A A A P P P P A A A A T T T T C C C C H H H H
F F F F
O O O O C C C C U U U U S S S S
A parameter can be a knob¨, slider or a selector switch (button). Put a parameter "in focus" by clicking
on it. An increment and decrement button appears below the knob or slider parameter as you move the
cursor over it, and the current setting of the parameter displays briefly in a yellow hintbox. When you
click on the parameter, the increment/decrement buttons (or button selectors) are highlighted. Note that
to be able to put a parameter in focus, the patch has to be active in the synthesizer.
If Nord Modular (not Micro Modular) is in Edit mode (by pressing the E
button), the parameter will
DIT
also be active in the Nord Modular D
, and you can adjust it with the R
D
. You move
ISPLAY
OTARY
IAL
the focus with the left and right N
buttons, or with the left and right arrow buttons on the
AVIGATOR
computer keyboard, or by clicking with the mouse. The left and right N
and arrow buttons
AVIGATOR
will only scroll through the parameters of one module.
To move the focus to another module in the patch, press and hold S
on Nord Modular, then jump
HIFT
between the modules with the up/down/left/right N
buttons. The Ctrl[PC]/Alt[Mac] key on
AVIGATOR
the computer keyboard together with the arrow buttons have the same function. Note that you have to
use the up/down arrow or up/down N
buttons to jump between modules that are placed
AVIGATOR
above/below each other in the patch window.
By the pressing the up/down N
buttons or the up/down arrow buttons on the computer key-
AVIGATOR
board, you can move the focus between the Morph group in the toolbar, the first module in the Poly
Voice Area and the first module in the Common Voice Area.
E E E E
D D D D I I I I T T T T I I I I N N N N G G G G
You can edit the parameters with the mouse. Place the cursor over a knob, click-hold it (put it in focus)
and then move the mouse. The knobs have no end stops; you may jump from maximum to minimum
by turning past the 6 o'clock position (if Knob control is set to 'Circular' in the Setup|Options dialog
box). When a knob is in focus, two small buttons will appear beneath the knob. Clicking on the 'up' but-
ton will increase the value for each click and clicking the 'down' button will decrease. You can also use
the computer keyboard + and - keys to increase and decrease the focused parameter value. Click on a se-
lector switch to select e.g. a waveform of an oscillator. The selected button will be "depressed". If Nord
Modular (not Micro Modular) is in Edit mode (by pressing the E
button), the highlighted parameter
DIT
will also be active in the Nord Modular D
, and you can edit it with the R
D
.
ISPLAY
OTARY
IAL
Editing a knob
Editing a button
Page 27
Advertisement
Table of Contents
