Clavia Nord Modular V3 User Manual page 130

7. Module reference: LFO group
A A A A
W W W W O O O O R R R R D D D D A A A A B B B B O O O O U U U U T T T T S S S S L L L L A A A A V V V V E E E E
The rate of slave LFOs can be controlled by a master LFO. The gray Slv output of a master module should
be connected to the gray Mst input of the slave module. If you refrain from connecting a master LFO to
a slave, it will produce a waveform at the rate set with the Rate knob.
LFOS LFOS LFOS LFOS A A A A
L L L L V V V V
This slave LFO produces one of five selectable waveforms. The rate can be controlled from a master LFO,
the cycle can be forced to restart and the phase of the waveform can be controlled.
M M M M
S S S S T T T T I I I I N N N N P P P P U U U U T T T T
A gray control input, for the frequency of the slave LFO to be controlled by a master module. Patch this
input to a Slv output on a master module. If you connect a master oscillator to this input, the slave LFO
will track the oscillator five octaves below the pitch of the oscillator.
R R R R
S S S S T T T T I I I I N N N N P P P P U U U U T T T T
The yellow Rst input forces the LFO to restart each time it receives a signal that changes from 0 units or
below to anything above 0 units. This signal could come from a gate output of a Keyboard or Sequencer
module, for example.
D D D D
I I I I S S S S P P P P L L L L A A A A Y Y Y Y B B B B O O O O X X X X
Displays either the LFO ratio related to the master rate, or the rate in Hz or seconds. Click to switch unit.
R R R R
A A A A T T T T E E E E
Sets the frequency of the LFO. The frequency will be displayed as a ratio, in relation to the master module
connected to the Mst input. The rate LED above the output will show you an approximation of the fre-
quency. Range: 0.025 to 38.05 times the master rate or 62.9 seconds/cycle to 24.4 Hz.
M M M M
O O O O N N N N O O O O
Synchronizes modules in polyphonic patches to each other. This means that if you play a chord, the mod-
ule will control all voices in sync (see
of this parameter is Off.
P P P P
H H H H A A A A S S S S E E E E
Sets the starting point of the LFO cycle. Range: -180 to +177 degrees. The set degree is shown in the
display box to the left of the knob.
G G G G R R R R A A A A P P P P H H H H
The graph illustrates one cycle and its phase.
W W W W
A A A A V V V V E E E E F F F F O O O O R R R R M M M M S S S S E E E E L L L L E E E E C C C C T T T T O O O O R R R R S S S S
Selects one of the five available waveforms.
Page 122
LFO LFO LFO LFO
S S S S
"The Mono parameter" on page 44
NORD MODULAR V3.0
for details). The preset setting