Clavia Nord Modular V3 User Manual page 78

6. Editor reference
settings. This is described in
be stored automatically.
N N N N
A A A A M M M M E E E E
Key in a name for your connected Nord Modular. This is especially useful if you run several (up to four)
Nord Modular/Micro Modular synthesizers from the Editor.
MIDI MIDI MIDI MIDI
C C C C H H H H A A A A N N N N N N N N E E E E L L L L
Set the MIDI channel for each slot. This channel will be used for reception and transmission of MIDI
messages.
MIDI Active check box:
Place a check in the corresponding box to activate the slot to receive and transmit MIDI messages.
MIDI MIDI
MIDI MIDI
C C C C L L L L O O O O C C C C K K K K
Set the clock source for the MIDI Clock. If External is activated, any incoming MIDI clock can be used
as a clock source in a patch. If Internal is activated, set the Rate in BPM (beats per minute). The BPM
setting has no effect if External is selected.
Global sync:
The MIDI Clock transmits 24 pulses per quarter note. The clock pulses can be divided using the Global
sync function, and be sent as logic signals at the Sync output of the MIDI Global module. These logic
signals can be used to synchronize the internal sequencer modules to an external MIDI sequencer. A set-
ting of 4 (quarter notes) will result in one logic pulse for every 96 pulses from the System Clock, which
is equal to one pulse for every fourth quarter note.
This logic pulse can be used for resetting the sequencer modules in Nord Modular to the "first beat in
the bar". If you do not use this function, the sequencer modules have no chance of knowing where they
are in a bar. With the Global sync function activated, it will never take longer than the set number of
quarter notes for the sequencer modules to realign themselves if you decide to start a MIDI sequence in
the middle of a song.
If you are synchronizing Nord Modular to a MIDI Clock source, this function will keep track of any in-
coming MIDI Song Position Pointer messages.
Page 70
"Save Synth Settings" on page
NORD MODULAR V3.0
51. On Micro Modular, the changes will