Clavia Nord Modular V3 User Manual page 127

NORD MODULAR V3.0
H H H H , L , L , S , S
, L , L , S , S
I I I I O O O O U U U U B B B B
Selects one of three ranges of the LFO rate, high, low or sub. The Hi range is from 0.26 Hz to 392 Hz,
the Lo range is from 0.02 Hz to 24.4 Hz and the Sub range is from one cycle completed in 699 seconds
to one cycle completed in 5.46 seconds.
P P P P
H H H H A A A A S S S S E E E E
Sets the starting point of the LFO cycle. Range: -180 to +177 degrees. The set degree is shown in the
display box to the left of the knob.
G G G G R R R R A A A A P P P P H H H H
The graph illustrates one cycle and its phase.
KBT KBT KBT KBT
This is the keyboard tracking function. If this is set to Key, the LFO will track the keyboard with a dou-
bling of the LFO frequency for each octave. Turning clockwise from the center position will increase the
tracking, turning counter clockwise, will decrease it. Off disconnects the keyboard tracking completely.
Click on the triangle above the control to set the keyboard tracking to Key. The preset value is Off.
W W W W
A A A A V V V V E E E E F F F F O O O O R R R R M M M M S S S S E E E E L L L L E E E E C C C C T T T T O O O O R R R R S S S S
Selects one of the five available waveforms.
M M M M
Click on this button to mute the control signal output of the module.
O O O O
U U U U T T T T
The LED above the output shows an approximation of the current LFO rate.
Signal: Bipolar.
LFOB LFOB LFOB LFOB
This LFO produces a square/pulse wave. The width of the pulse can be controlled and modulated. The
rate of the LFO can be modulated by a modulation source and the keyboard. The wave cycle can be
forced to restart and the phase of the waveform can be controlled.
R R R R
S S S S T T T T I I I I N N N N P P P P U U U U T T T T
The yellow Rst input forces the LFO to restart each time it receives a signal that changes from 0 units or
below to anything above 0 units. This signal could come from a gate output of a Keyboard or Sequencer
module, for example.
S S S S
L L L L V V V V O O O O U U U U T T T T P P P P U U U U T T T T
This is a gray output for controlling the rate of a slave LFO. Patch this output to a Mst input on a slave
module. If you control a slave oscillator, it will track the LFO five octaves above the LFO rate.
7. Module reference: LFO group
Page 119