Table of Contents
Advertisement
NORD MODULAR V3.0
R R R R
-/A
-/A
-/A
-/A
I I I I N N N N G G G G
M M M M P P P P L L L L I I I I T T T T U U U U D D D D E E E E M M M M O O O O D D D D U U U U L L L L A A A A T T T T O O O O R R R R P P P P A A A A T T T T C C C C H H H H E E E E X X X X A A A A M M M M P P P P L L L L E E E E
You can easily create a ring- or amplitude modulator by using two oscillators and the GainControl mod-
ule described above. Connect the modules according to the figure below. See also the module
on page
164.
OscA is the modulator and OscB the carrier in this example. With the Unipolar button on the
GainControl module not depressed, the setup functions as a ring modulator. With the Unipolar button
depressed the setup works as an amplitude modulator.
X-F
X-F
X-F
X-F
A A A A D D D D E E E E
This mixer can be modulated by a control signal to produce a crossfade between two incoming signals.
X-
X-
X- X-
F F F F A A A A D D D D E E E E M M M M O O O O D D D D U U U U L L L L A A A A T T T T I I I I O O O O N N N N I I I I N N N N P P P P U U U U T T T T
The red modulation input of the X-fade module. Connect a modulator here. The amount of modulation
is controlled with the knob.
1/2
1/2
1/2
1/2
K K K K N N N N O O O O B B B B
Sets the initial mix of the two signals. If you set the knob towards 1, the initial mix will have more of the
signal connected to the number 1 input, if you set it towards 2, the initial mix will have more of the signal
connected to the number 2 input. Clicking on the triangle will set the mix to an equal amount of both
signals.
I I I I
1, 2
1, 2
1, 2
1, 2
N N N N P P P P U U U U T T T T
The red audio inputs.
O O O O
U U U U T T T T P P P P U U U U T T T T
Signal: Bipolar.
[A
[A
T T T T
I] I] I] I]
[A
[A
T T T T T T T T E E E E N N N N U U U U A A A A T T T T O O O O R R R R
Y Y Y Y P P P P E E E E
7. Module reference: Mixer group
"RingMod"
Page 149
Advertisement
Table of Contents
