Clavia Nord Modular V3 User Manual page 165

NORD MODULAR V3.0
S S S S &H &H &H &H
A A A A M M M M P P P P L L L L E E E E O O O O L L L L D D D D
This module takes samples of the values of an incoming signal. The sampling occurs every time a signal
shifting from 0 units or below to anything above 0 units appears at the yellow logic input. Inbetween
these trig signals, the module transmits the value of the latest sample to the output.
T T T T
R R R R I I I I G G G G I I I I N N N N P P P P U U U U T T T T
Connect the signal to activate the sampling process to this yellow input.
I I I I
N N N N P P P P U U U U T T T T
The red audio input.
O O O O
U U U U T T T T
Signal: Bipolar.
To create the traditional Sample & Hold or random LFO synthesizer effect, connect the output of a white
noise generator module to the input of the Sample & Hold module and trig the Sample & Hold module
with an LFO. Connect the output of the Sample & Hold module to a Pitch modulation input of an os-
cillator according to the figure below:
D D D D
I I I I O O O O D D D D E E E E
The Diode Processing module can change a bipolar signal to a unipolar signal. You can choose whether
you want to discard of any negative input levels, or if you want to transform these to positive levels.
S S S S
E E E E L L L L E E E E C C C C T T T T O O O O R R R R
Sets the operation of the module. The leftmost position leaves the signal unchanged (bypass), the middle
(Half) position discards of any negative input signal levels and the right (Full) position transforms (mir-
rors) any negative signal levels to positive levels.
I I I I
N N N N
The red audio input.
O O O O
U U U U T T T T
Signal: Bipolar or Unipolar.
7. Module reference: Audio Modifier group
Page 157