Alarm Troubleshooting - Clarion SR5000 Installation Manual

neutral safety switch. (See H3/6 BLACK/WHITE neutral safety switch input in Remote
Start Harness Wire Connection Guide section of this guide.)
If the starter does not engage, the test is complete.
Once the system passes the three tests, the vehicle can be re-assembled and delivered. Do not the
use the remote start system or finalize the installation if it fails any of the safety check tests.
Troubleshooting

Alarm Troubleshooting

Starter kill doesn't work:
Is the correct wire being interrupted? If the car starts when the starter kill relay is completely
disconnected, the wrong starter wire has been cut and interrupted.
Is the yellow wire of the starter kill relay going to primary ignition? This wire must be powered
in the run and start positions.
Shock sensor doesn't trigger the alarm:
Has the false alarm prevention circuitry system been triggered? If so, you will hear 5 chirps when
disarming. To check this, turn the ignition key on and off to clear the false alarm prevention
circuitry's memory, and then retest the shock sensor. For a detailed description of false alarm
prevention, see false alarm prevention circuitry section of this guide.
Door input does not immediately trigger full alarm. Instead, chirps are heard for the first 3 seconds:
That's how the progressive two-stage door input works! This is a feature of this system. This is
an instant trigger, remember, since even if the door is instantly closed again, the progression
from chirps to constant siren will continue.
Closing the door triggers the system, but opening the door does not:
Have you correctly identified the type of door switch system? This happens often when the
wrong door input has been used. (See Door Lock Harness Wire Connection Guide section of
this guide.)
39